To set up VoIP phone to work with CallServer module you need to set up the following options (title may vary for different phones). The N here represents the number of line, i.e. 1, 2, 3 etc:
phone number: line_N
account: line_N
password: value that you entered in Phone Register Password in Common Settings (it is 12345 by default)
sip proxy: IP address of your PC where the CallServer runs
domain: IP address of your PC where the CallServer runs
rtp port: the only requirement that for each line in the same network this value must be different (we recommend to follow some clear scheme, e.g. 5000+N for N-th line)
register ttl: we recommend 60 seconds (the phone will ping CallServer every 60 seconds)
If all configuration settings for the VoIP phone were entered properly, then after saving settings and rebooting, the phone should register at the CallServer (which must be running). Usually phones display some pictogram or just display 'line N' at the LCD. In addition, the corresponding Line State Window at the main screen of GUI should become active (colored).
Screenshot below represent view of main screen when the 1 st line is registered: |
